LED EMERGENCY GEAR
INTRODUCTION




We have a vast range of LED emergency gear, output voltage ranges from 10 – 300V, able to drive either the LED driver itself when there is a power failure, or the LED panel/fitting/strip directly. Light output options on emergency vastly range from a mere 5% to 100%, also with duration times from 30 minutes to 3 hours and up.
HOW DO I KNOW WHICH LED EMERGENCY GEAR TO USE?
This may be a daunting task at first, but it is actually very simple. Begin by looking on the LED panel/module that you would like to power on emergency operation, take note of the voltage range of the panel. If the panel states that it is 80V for example, then you may look at the Cosine LED emergency table to see which pack is suitable for your application – noting the range of each pack, if your module falls between the range it will be compatible.
Sometimes the circuitry in the LED module/panel may be power factor corrected, or contain other intelligent circuitry, where it can potentially pose a problem with some emergency gear. If this is the case, or you are unsure, do not hesitate to call the Cosine Developments Durban branch for assistance.
LED EMERGENCY GEAR PRODUCTS

OMEGA CONVERSION KIT
CONSTANT CURRENT KIT
The all in one OMEGA Conversion Kit provides constant current to any LED module or panel that requires a
voltage between 10 – 300Vdc…

LED UNIVERSE
CONSTANT CURRENT (2 CELL) KIT
The LED Universe is used for modules or panels with external LED drivers. It can operate any LED’s that has a forward voltage of 10 to 300V dc…

LED UNIVERSE FC
CONSTANT CURRENT (2 CELL) KIT
The LED Universe FC is designed to charge the battery within 3 – 6 hours depending on the capacity used. The unit provides constant current to any LED module or panel that requires a voltage between 10 – 300Vdc…

LED UNIVERSE DELTA
CONSTANT CURRECT (2 CELL) KIT
The LED Universe Delta is used for modules or panels or LED tubes with onboard LED drivers. It can operate LED’s that has a forward voltage of 10 to 300Vdc with internal circuits using low currents…

LED HYDRA
CONSTANT CURRENT KIT
The LED Hydra emergency pack provides a constant current of 400mA – 500mA to any LED requiring a voltage from 30 to 56Vdc…

LED ORBIT
CONSTANT CURRENT (6 CELL) KIT
The LED Orbit provides constant current to any LED module or panel that requires a voltage between 10 – 100V. It has to be used in conjunction with either a 6x2Ahr or 6x4Ahr Ni-Cad battery to provide the emergency illumination…

LED 20W cc
CONSTANT CURRENT KIT
The unit is housed in either a plastic or explosion proof housing upon request. A safety start circuit is provided which prevents emergency operation until the mains is connected and disconnected…

LED 40W cc
CONSTANT CURRENT KIT
The emergency control gear uses a 12V battery , Li-ion or NiCad battery types. A red pilot light shows that the batteries are being charged…

LED STAR
CONSTANT CURRENT KIT
The LED Star provides constant current to LED modules, strips or panels that requires a voltage between 10 – 150Vdc. It has a built-in single cell lithium-ion battery to provide the emergency duration…