Full light output emergency kit
> 5 year warranty on inverter
> Full emergency light output – 100%
> Emergency lighting kit for fluorescent lamps from 6 to 65W
> Emergency lighting duration of one hour
> Maintained or non-maintained operation
The TL40_100% emergency control unit provides 100% light output for one hour using either a 36 Watt T8 or 40 Watt T12 fluorescent lamp. The TL65_100% emergency control unit provides 100% light output for one hour using either a 58 Watt T8 or 65 Watt T12 fluorescent lamp. The unit complies with SABS 1464 Part 22 and therefore provides all necessary battery charging, low voltage cut-off, protection and performance criteria. A battery pack of 10 x 4 Ahr nickel-cadmium cells is required for the TL40_100% and a battery pack of 16 x 4 Ahr nickel-cadmium cells is required for the TL65_100% version and is available in electronic and switch start ballast.
The light output may vary depending upon lamp type, ambient temperature, mains voltage and ballast, and so the light output must be measured to ensure compliance to SABS 1464 Part 22. A 10% variation must also be allowed for production spread in control units.
Either maintained or non-maintained mode can be used. A safety start circuit is provided that prevents emergency operation until mains is connected. This enables installation without disconnecting or depleting the batteries. A red pilot light indicates that the batteries are being charged. The unit is housed in an alu-zinc case which includes a wiring connection diagram.
